4/2/2023 0 Comments Aili 500a battery monitor![]() ![]() How come it is higher than that? Is that because the Charge Limit is at 15. Based on the parameters I would expect that the MPPT keeps the voltage at 14.6V during the Boost/Absorption phase. However, when the solar panels are charging the batteries the MT50 display shows 14.8V or even 14.9V. ![]() Or do you have any further recommendations? Below I posted the list.Īnother question. The larger unit, with a 500A shunt, is under 80 and may be found on Amazon, eBay and other online retailers. I prefer the larger display, but it is a bit more expensive. However, since yesterday I saw the 13A charge (with the battery at 12.88V) rather than the 2A I saw before, I am more confident about the setup.įor now I am planning to change the "Boost Charge" from 14.6V to 14.4V & change Equalize time to "0" and leave the other charging parameters intact. 500ALarge Display The 500A version has a larger display panel, and it displays SoC, amps, volts, watts and time all together on one screen with no buttons to push. Yes, I am very happy with it, thanks heaps! To test the charging more thoroughly is my next step. Does anyone have any clue what the wiring issue could be? Simple fix hopefully? I contacted the company to tell them about this issue, however they have no clue how to wire it differently. Whereas it should distract the -7 amps discharge and show a net of +6 amps. When I turn on all my devices the current increases to +20 Amps or so. Through my solar panel it shows +13 Amps. I go through each step including how to program it for the best results.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |